Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Disable 802.11a

Hi

We are having 5508 controller with Lightweight access points 1142, IS it possible to disable 802.11a on certain access points before turning it off completely on the controllers?? Could you provide steps for doing so on WCS?

Thanks

Krithika

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Disable 802.11a

You're looking at the b/g/n there and not the a/n.  But the option is Admin Status.  Uncheck the box to disable the radio.

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
5 REPLIES

Disable 802.11a

Yes it is possible.  In the AP config, you should have the option to enable/disable the radio on a per AP basis.

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Disable 802.11a

hi

This is what I see under the Config AP .  I dont seem to pick up where I could disable radio per AP basis here.

Could you please clarify?

thanks again

Re: Disable 802.11a

You're looking at the b/g/n there and not the a/n.  But the option is Admin Status.  Uncheck the box to disable the radio.

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Disable 802.11a

That worked! Thank you very much..

I did that on one of our APs and will turn off 802.11a eventually on controllers.

New Member

Re: Disable 802.11a

Hi Stephen,

is saw this post regarding the disabling of the radio per AP, but when i have disabled the raidio i cannot turn it back on. It is saying "Error in enabling Admin Status"

How can i change this?

407
Views
0
Helpful
5
Replies
CreatePlease to create content