Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Disabling "A" Radio in a 1252

Simple question - does removing the checkmark next to the "Admin Status" field disable the "A" radio completely?  I'm trying to prevent power alarms b/c we don't have sufficient POE to power up both A and B/G radios.

TIA,

Amir

Everyone's tags (2)
1 REPLY
Cisco Employee

Re: Disabling "A" Radio in a 1252

Unfortunately, to my knowledge you need to physically remove the radio module to get enough power. They were talking about improving this on newer releases.

For sure, if you disable the admin state of the A radio, you need to reboot the AP afterwards so that it comes back in full-powered mode on the remaining module.

Nicolas

===

Please rate answers that you find useful

268
Views
0
Helpful
1
Replies
CreatePlease to create content