Hi! I have a WLC 4402 connected to a SW 4500 and this one connected to an AP 1000. When i use the AP-Manager interface and the Management interface, both on the same vlan, the ap registers and it's ok, but when i get the AP-Manager on a different subnet than the Management interface, the ap doesn't get registered.
This is the error message:
*Mar 24 12:47:26.378: 00:23:04:1a:54:73 Received LWAPP DISCOVERY REQUEST from AP 00:23:04:1a:54:73 to 00:21:a0:38:1d:63 on port '1'
*Mar 24 12:47:26.378: Discovery Request received on wrong VLAN '30' on interface '1', management VLAN = '90' - in L3 mode, dropping the packet
You will get that as long as your management interface and ap-manager interface is not on the same subnet. The ap's talk to the ap manager, but any network traffic will egress out the management interface.... Only when the LAP has joined will the ap-manager and AP communicate throught the LWAPP tunnel. The way you have this will not work since deployment one wlc's is always to pur the management and ap-managers on the same subnet.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...