cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
260
Views
0
Helpful
1
Replies

Do I need a new FUS image when upgrading controller code?

tdennehy
Level 1
Level 1
We want to do the upgrade on WiSM2sfrom 7.0.220.0 to 7.4.121. for two modules. 
We want to support a license for 1000 APs.
Both wisms are running field recovery image 7.0.43.32
No HA configured.

 

How do I determine if I need to install a new FUS image when I upgrade the code?  Is there a matrix out there that I cannot seem to find?

 

Thanks in advance.

1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

Yes, you'll need to upgrade your FUS image as well, to 1.7.0.0

 

When you look at the release notes in the upgradeing software section it should tell you what FUS shoudl be running.

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn74mr02.html#pgfId-976667

 

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

Yes, you'll need to upgrade your FUS image as well, to 1.7.0.0

 

When you look at the release notes in the upgradeing software section it should tell you what FUS shoudl be running.

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn74mr02.html#pgfId-976667

 

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: