I'm troublehooting a Reset Radio Interface, wich is stucked in Reset Status.
I think its all configured, but the Radio dont comes up.
I've not GUI access, so im configuring all by CLI (telnet).
In attach i post the configurationof the AP, as weel as other output that i think u might be interested.
In WLSE, when i see Fault Reports, it appears the following messages:
Inconsistent device state found: Device "AP-36.luvzone.ulusofona.pt": ifIndex=1, MAC=00-24-14-8c-f9-80: "CISCO-DOT11-IF-MIB cd11IfStationConfigTable.cd11IfStationRole must be in the range [1..11] (was 0)"
The subinterfaces are off with this configuration. The AP only shows having a b/g radio (dot11Radio0) but all of the subinterfaces are assigned to dot11Radio1. Because of this the VLANs aren't created on the radio interface and it won't come up. Try deleting the current subinterfaces and recreating them under the dot11Radio0 interface.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...