05-13-2009 12:31 PM - edited 07-03-2021 05:35 PM
we created a dynamic interface on WLC and associated a one ssid using dhcp but this interface do not obtain IP
could you help me to resolve this case on wlc?
regards,
05-13-2009 02:01 PM
Errr ... Dynamic Interface requires STATIC IP Address.
05-13-2009 06:29 PM
the dynamic interface requires static IP address, but the wlan clients can get ip using dhcp server.
05-14-2009 01:39 AM
The dynaminc interface is configure to be static.Then from the GUI goto CONTROLLER----INTERNAL DHCP SERVER----DHCP SCOPE
But the dynamic interface must be in the same ip subnet with the dhcp scope you created. You then need to tie it with the SSID u want. STEP click WLAN-----then the wlan id no---------GENERAL----Inteface u and put the dynamic inteface u just created.
07-29-2009 10:36 AM
I have a similar problem, I have setup one SSID tie to management interface which is configured to using external DHCP server,that works fine. Now I tried to enable a dhcp scope 10.10.10.0/24 on WLC, create dynamic interface 10.10.10.1,and dhcp server point to managment interface, then create another SSID using this dynamic interface, but client can't get ip.
07-29-2009 11:07 AM
Are you pointing to an external DHCP server or a scope internal on the controller?
Do you have DHCP proxy enabled or disabled on the controller?
07-29-2009 12:09 PM
First one points to external dhcp through managment interface, second one to a scope internal on the wlc. DHCP proxy is enabled.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: