The dynaminc interface is configure to be static.Then from the GUI goto CONTROLLER----INTERNAL DHCP SERVER----DHCP SCOPE
But the dynamic interface must be in the same ip subnet with the dhcp scope you created. You then need to tie it with the SSID u want. STEP click WLAN-----then the wlan id no---------GENERAL----Inteface u and put the dynamic inteface u just created.
I have a similar problem, I have setup one SSID tie to management interface which is configured to using external DHCP server,that works fine. Now I tried to enable a dhcp scope 10.10.10.0/24 on WLC, create dynamic interface 10.10.10.1,and dhcp server point to managment interface, then create another SSID using this dynamic interface, but client can't get ip.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...