Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EDRRM AQ and AQI

Hi ;

 

     Whats the difference between EDRRM AQ and AQI. If we are setting the  sensitivity on the EDRRM to high the value will be 60. Whats the value we are configuring the AQI in the clear air tab. is it only for traps.

 

If i want to change the AP  channel  based on the AQI value where i should set . 

 

I should change the EDRRM to high or change the AQI value in the clean air.

 

Thanks & Regards

Sreejith R

 

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi Sreejith,Yes, that should

Hi Sreejith,

Yes, that should be fine.

Pls mark this thread "answered" if this clarify your query.

HTH

Rasika

3 REPLIES
VIP Purple

Hi Sreejith,Here is some

Hi Sreejith,

Here is some reference post on this topic

http://mrncciew.com/2013/05/02/event-driven-rrm/

If you change the sensitivity to "high", then it is good idea to change AQI alarm threshold to 60 as well. Yes AQI threshold is only for traps.

You need to enable Clean Air & change EDRRM sensitivity (High-60, Medium-50, Low-35) in order to change  AP channel based on AQI value of 60,50 or 35

 

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Thanks Rasika So it means if

Thanks Rasika

 

So it means if we want to trigger the channel change based on AQI , its not necessary to change the AQI threshold

 

Only change the EDRRM to low/medium/high and enable clean air.

Please confirm

 

VIP Purple

Hi Sreejith,Yes, that should

Hi Sreejith,

Yes, that should be fine.

Pls mark this thread "answered" if this clarify your query.

HTH

Rasika

249
Views
0
Helpful
3
Replies
CreatePlease to create content