Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

enable spanningtree portfast on switch for AP1200

Hi do i enable spanning tree portfast on a switch connting to a ap1200 my current configuration is:

interface FastEthernet0/20

description Wireless_2_W_1

switchport trunk encapsulation dot1q

switchport mode trunk

i am getting a lot of flapping and was wondering if this could help

5 REPLIES
Green

Re: enable spanningtree portfast on switch for AP1200

I don't think that portfast works with trunk ports, only access ports ... perhaps that's part of the problem.

STP will normally keep a port down for ~55 seconds, once it's up, it's up....until the other end drops (powers down, for example)or you reset / power-cycle the switch.

What is the timeframe of the flapping cycle how long down, how long up)?

Do the logs give you any error mesages?

What error messages do you see at the consoles of the AP and switch?

Let us know, or post 'em ....

Good Luck

Scott

New Member

Re: enable spanningtree portfast on switch for AP1200

Hi these are the message i get on the core switches

24w2d: %C4K_EBM-4-HOSTFLAPPING: Host 00:16:6F:42:8A:33 in vlan 22 is flapping between port Gi2/18 and port Gi2/5

This i drill down to the access switch where the wireless device is attached: But this has no error the erros are seen on the cores above. No errors on the ap just core switches Hostflapping

Re: enable spanningtree portfast on switch for AP1200

Is this happening on lots of wireless client MAC addresses or just one?

Do you have more than one access point?

I have seen this behaviour when the client has bridged his Ethernet and Wireless adapters together, it actually caused a loop in the network and a broadcast storm ( The APs were not Cisco ).

It might also happen if there are two access points on the same channel, the client may send one conversation via one AP, and others through the second AP.

** Please Rate posts if helpfull **

New Member

Re: enable spanningtree portfast on switch for AP1200

This is typical of what I use:

interface GigabitEthernet3/46

description Wireless AP76

switchport access vlan 177

switchport trunk encapsulation dot1q

switchport trunk native vlan 177

switchport trunk allowed vlan 113,177,190,814

switchport mode trunk

speed 100

duplex full

spanning-tree portfast trunk

spanning-tree bpduguard disable

end

Depends too on whether the switch supports dot1q trunking natively. The 4503 switch in this example doesn't. 2950s do.

Re: enable spanningtree portfast on switch for AP1200

you will get this if you have mobile wireless clients as they move between APs, on on the Switch interface the APS are connected to I put the following command to supress these messages

no logging event addr-flap

HTH

Richard.

802
Views
0
Helpful
5
Replies