04-10-2014 01:06 PM - edited 07-05-2021 12:39 AM
Hi
Can I enable the ssh for all the AP which connected to the controller- either from controller or from PI? It take much time to configure the AP one by one...
Thanks
Solved! Go to Solution.
04-10-2014 02:18 PM
I am running 7.6.x & looks like it is a feature added in that version. Even 7.4.x I cannot see that option.
(5508-1) >show sysinfo
Manufacturer's Name............................ Cisco Systems Inc.
Product Name................................... Cisco Controller
Product Version................................ 7.6.100.8
HTH
Rasika
*** Pls rate all useful responses ****
04-11-2014 07:32 AM
If you have prime infrastructure, you can create a lightweight AP template that enables SSH and then select all your APs. This should work for all controller code versions.
04-10-2014 01:38 PM
Hi
go to WLC CLI & apply the below command
(5508-1) >config ap ssh enable all
SSH will be enabled in the Cisco APs joining henceforth
(5508-1) >save config
Are you sure you want to save? (y/n) y
Configuration Saved!
HTH
Rasika
**** Pls rate all useful responses ***
04-10-2014 01:45 PM
Hi Rasika,
which version are you using? from the 7.0.98 i do not have this "all" configuration..
(Cisco Controller) >config ap ssH enable ?
<Cisco AP> Enter the name of the Cisco AP.
(Cisco Controller) >config ap ssH enable all
Cisco AP name is invalid.
04-10-2014 02:18 PM
I am running 7.6.x & looks like it is a feature added in that version. Even 7.4.x I cannot see that option.
(5508-1) >show sysinfo
Manufacturer's Name............................ Cisco Systems Inc.
Product Name................................... Cisco Controller
Product Version................................ 7.6.100.8
HTH
Rasika
*** Pls rate all useful responses ****
04-11-2014 06:48 AM
thanks Rasika
04-11-2014 06:46 AM
up need to upgrade .
04-11-2014 07:32 AM
If you have prime infrastructure, you can create a lightweight AP template that enables SSH and then select all your APs. This should work for all controller code versions.
10-02-2020 05:02 AM
I am not on this version but any new people finding this thread:
Cisco WLC > Advanced > Wireless > Access Points > Global Configuration > Global Telnet SSH > SSH
01-10-2024 06:03 PM
do i need to create usrname ands password for it?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: