Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

enable ssh for all the ap?

Hi

 

Can I enable the ssh for all the AP which connected to the controller- either from controller or from PI? It take much time to configure the AP one by one...

 

Thanks

2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Purple

I am running 7.6.x & looks

I am running 7.6.x & looks like it is a feature added in that version. Even 7.4.x I cannot see that option.

(5508-1) >show sysinfo

Manufacturer's Name............................ Cisco Systems Inc.
Product Name................................... Cisco Controller
Product Version................................ 7.6.100.8

 

HTH

Rasika

*** Pls rate all useful responses ****

Bronze

If you have prime

If you have prime infrastructure, you can create a lightweight AP template that enables SSH and then select all your APs. This should work for all controller code versions.

6 REPLIES
VIP Purple

Higo to WLC CLI & apply the

Hi

go to WLC CLI & apply the below command

 

(5508-1) >config ap ssh enable all

SSH will be enabled in the Cisco APs joining henceforth

(5508-1) >save config 

Are you sure you want to save? (y/n) y

Configuration Saved!

 

HTH

Rasika

**** Pls rate all useful responses ***

 

Community Member

Hi Rasika, which version are

Hi Rasika,

 

which version are you using? from the 7.0.98 i do not have this "all" configuration..

(Cisco Controller) >config ap ssH enable ?
               
<Cisco AP>     Enter the name of the Cisco AP.

 

(Cisco Controller) >config ap ssH enable all

Cisco AP name is invalid.

 

VIP Purple

I am running 7.6.x & looks

I am running 7.6.x & looks like it is a feature added in that version. Even 7.4.x I cannot see that option.

(5508-1) >show sysinfo

Manufacturer's Name............................ Cisco Systems Inc.
Product Name................................... Cisco Controller
Product Version................................ 7.6.100.8

 

HTH

Rasika

*** Pls rate all useful responses ****

Community Member

thanks Rasika

thanks Rasika

Silver

up need to upgrade .

up need to upgrade .

Bronze

If you have prime

If you have prime infrastructure, you can create a lightweight AP template that enables SSH and then select all your APs. This should work for all controller code versions.

1893
Views
0
Helpful
6
Replies
CreatePlease to create content