I needed to upgrade the IOS on my 350 AP. The upgrade failed in the middle. When I rebooted I noticed that I had an older version and the Aironet Logo was displayed. I resumed the download and it worked this time. I noticed that I could not associate with it so I did some troubleshooting and found that it keeps changing the role in radio network from access point to client. Even in set up when it said Access point if I went to express setup under the role in network it says it is a site survey client and I can't change this. Does anyone know a fix for this.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...