Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Error in firmware upgrade

I was upgradeing the firmware in an access point and it failed halfway through. Now I get the following error message. Failed to start driver for port "awc0" (errno=0x006d0002). Is there a way to fix this without sending back to the factory?

1 REPLY
Cisco Employee

Re: Error in firmware upgrade

The AWCO message occurs when the radio can't be configured.

Let us know which firmware was Access Point was already on and which one you are trying to upgrade to ???

Here is a link which discuss step by step procedure for upgrading firmware for Access Points thru console port..See if that helps..

http://www.cisco.com/warp/public/102/wlan/ap-fw-upgrade.html

Thanks..Tejal

399
Views
0
Helpful
1
Replies
CreatePlease to create content