Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Error in setting country code -- Wireless Lan Controller

Hi all

try to setup a LAP for Singapore office, has encounter above errror message.

Following Country codes:   AU, KR,NZ,PH,SG  has been enalbed in Country Page. the LAP AIR-CAP3502I-S-K9  has been associated with KR intially. We try to change it to SQ, but the error persists.  this AP has been setup as HREAP,  any suggestion? 

Thanks

Roy

3 REPLIES

Re: Error in setting country code -- Wireless Lan Controller

Do you still have the AP local to you do you could capture the console output while setting the country?

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Error in setting country code -- Wireless Lan Controller

Yes Stephen, I still have it with me ( in Sydney). I would like to test it before send them to Singapore. should I wait for it to be pluged into Singapore office then configure the contry code?

New Member

Error in setting country code -- Wireless Lan Controller

find the answer: disable the access point then it allow country code to be changed.

3204
Views
5
Helpful
3
Replies