Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

FATAL errors in Cisco 350 AP

I would appreciate the feedback for the following messages in wireless AP

Radio Enable Failed with error "Bad Authentication Type". Temporarily Disabling WEP Encryption and re-Attempting Enable. THIS ERROR MAY INDICATE TAMPERING WITH THE RADIO AND/OR ITS ENCRYPTION KEYS!

Please note that I am not using WEP in the AP. Would there be a site for wireless AP error messages and the possible solution. Thanks.

3 REPLIES
Bronze

Re: FATAL errors in Cisco 350 AP

The resolution to your error message is the following.

Reset the access point WEP configuration. If this message appears continuously, reload the access point firmware.

This was pulled from the following URL that will assist you with future messages as well. I would try to reset the AP back to factory defaults and reconfigure the unit. Last resort would be to reload the firmware.

http://www.cisco.com/en/US/products/hw/wireless/ps458/products_configuration_guide_chapter09186a008007f78a.html

New Member

Re: FATAL errors in Cisco 350 AP

Thanks for the feedback. Please note I have not enabled WEP and I am employing third party security to secure the wireless network. The AP's are not WEP enabled.

Simha

Bronze

Re: FATAL errors in Cisco 350 AP

I understand that you are not using WEP. I suggest that you reset the AP to factory defaults and reconfigure the unit to see if that eliminates the error messages. If it does not, then you will need to either reload the firmware as suggested by the URL or upgrade your firmware.

238
Views
0
Helpful
3
Replies
CreatePlease to create content