Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

FlexConnect VLAN Mappings Inheritance

Hi guys,

I have 3 APs, which joined the vWLC some time ago (FlexConnect mode). I setup the VLAN Mappings, add them to an AP Group and all went well.

After some time I started to use FlexConnect Groups. I have created a group for these three and add each to the group.

 

Trouble is, even after adding each AP to the FlexConnect Group the VLAN Mappings Inheritance stays on AP-Specific instead of Group-Specific.

I tried Remove AP Specific option, but I receive an error message I have attached.

 

Thanks in advance for any hint/tip.

Everyone's tags (1)
4 REPLIES

Hi Florin, my name is Gaston.

Hi Florin, my name is Gaston.

 I have the same issue. Do you manage the way to solve it?

Thank you!

Yes I did; I was using

Yes I did; I was using several 1242 AG APs and found out that this model have no support for this.

What AP hardware are you using?

Also what WLC software version you run?

There it is!!    I have 3 APs

There it is!!    I have 3 APs models. And this is the conclusion:

AIR-LAP1131AG-E-K9    No

AIR-LAP1142N-E-K9      Yes, it inherits.

AIR-CAP1602I-E-K9      Yes, it inherits.

 

Here is the reference:

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_010001001.html#task_06C2951A1353467FB7B705C114EA9E97

 

Thank you Florin !

New Member

Hi Florin,Hope you are doing

Hi Florin,

Hope you are doing well!

what is the version you are using in your controller and also the model?

Thanks//

Lenka

857
Views
5
Helpful
4
Replies
CreatePlease to create content