My network consists of a WLC, which is connected to the APs and a router through a switch. The router connects our network to a central location that provides internet. I would like to add a guest VLAN, which gets its IP addresses from the WLC's DHCP. However, I couldn't get it to work up to now. Firstly I created a new guest_Vlan:
and then the DHCP:
and then tie the guest wlan to the guest_vlan:
Is this correct? Is there anything else I need to do? If not, could you help me fill out the info correctly because I couldn't get this to work.
I want to use the WLC as a DHCP server that gives IP addresses from the range 10.0.0.1-10.0.0.30. My controller's IP address is 192.168.0.250 and my router's IP is 192.168.0.254.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...