Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H-reap ap´s not coming back to the controller.

I have a problem with the H-reap ap´s to come back to the controller.

1 - The ap goes into the H-REAP mode after a wan failure

2 -  Them after the wan link comes back the ap does not register back to the controller, that just works after ap´s are rebooted locally.

Ap: 1242ag

WLC: 4404 - Firmware 5.0.148.2

2 REPLIES
Hall of Fame Super Gold

Re: H-reap ap´s not coming back to the controller.

Upgrade to 6.0.182.0 or later and verify.

New Member

Re: H-reap ap´s not coming back to the controller.

We found that the command ip icmp redirect was configured on the router´s interface and after we disable this feature the problem stopped.

248
Views
0
Helpful
2
Replies
CreatePlease login to create content