Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

have to type "boot" each time the AP1131 is power up

Hi, after some problem with the installed IOS, hi upgrade the unit. After the upgrade, the AP don't want to boot automaticly, hi have to type manually "boot" to boot the unit. How can I fix that ?

Thanks !

1 REPLY
Hall of Fame Super Red

Re: have to type "boot" each time the AP1131 is power up

Hi Francis,

Have a look at the following;

Using the CLI

Enter the set BOOT command to designate the new image as the image that the access point uses when it reboots. The access point creates a directory for the image that has the same name as the image, and you must include the directory in the command. Your entry might look like this example:

ap: set BOOT flash:/c1200-k9w7-mx.122-13.JA1/c1200-k9w7-mx.122-13.JA1

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a0080209250.html#wp1048390

Hope this helps!

Rob

Please remember to rate helpful posts.....

178
Views
0
Helpful
1
Replies
CreatePlease to create content