Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

High Availability Configuration for AP in 5508 with 7.5.102.0

We have recently upgraded the controller to 7.5.102.0. Once the controller is upgraded i tried to change the high availability configuration for the access points. But it fails.

I am not able to set the primary and secondary controller name for the AP in 7.5.102.0

Any Clue?

Thanks & Regards

Sreejith R

  • Getting Started with Wireless
6 REPLIES
Hall of Fame Super Gold

High Availability Configuration for AP in 5508 with 7.5.102.0

I am not able to set the primary and secondary controller name for the AP in 7.5.102.0

What error message are you getting when you do this?  Make sure all your entries do not have a space before, between and after.

New Member

Re: High Availability Configuration for AP in 5508 with 7.5.102.

It's giving error in setting controller name. I am just changing from controller 1 to controller 2. No issue with space

Sent from Cisco Technical Support iPhone App

VIP Purple

Re: High Availability Configuration for AP in 5508 with 7.5.102.

Post the WLC CLI output of "show ap config general "  command for one of your AP. If nothing is configured  for HA or HA configured value to be changed, try the below CLI commands for that AP & see what error message you got on CLI

(WLC ) >config  ap secondary-base

(WLC ) >config  ap primary-base


HTH

Rasika

**** Pls rate all useful responses ****

Hall of Fame Super Gold

High Availability Configuration for AP in 5508 with 7.5.102.0

It's giving error in setting controller name.

Dude,

You are NOT helping.  The error message is very specific. 

I will repeat my question again:  What is the EXACT error message?

Hall of Fame Super Gold

High Availability Configuration for AP in 5508 with 7.5.102.0

I am just changing from controller 1 to controller 2.

Did you move the WLC 1 details into WLC 2 and leaving WLC 1 blank? 

New Member

Re: High Availability Configuration for AP in 5508 with 7.5.102.

If you trying to change the setting from an AP template on the Cisco Prime, you might have a Google chrome Issue.

Try to configure it directly on the WLC.

259
Views
0
Helpful
6
Replies