Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How can I configure my AP 1252 to use the same WPA2 SSID on both bands?

I am trying to configure my AP 1252 to use WPA2 on both bands (dual radio).

But the GUI is trying to make me go nuts...

If someone can post a CLI sample config... that would be GREAT!

Kind regards

2 ACCEPTED SOLUTIONS

Accepted Solutions

Sorry I attached the example.

Sorry I attached the example.

Hall of Fame Super Silver

Since your defining WPA

Since your defining WPA version 2, I would not configure TKIP as the encryption also. Just leave the encryption to AES-CCM.

Scott

-Scott
*** Please rate helpful posts ***
5 REPLIES

Hi.

Hi. There is an example: ap(config)#dot11 ssid ap(config-ssid)#vlan ap(config-ssid)#mbssid guest-mode ap(config-ssid)#authentication open ap(config-ssid)#authentication key-management wpa version 2 ap(config-ssid)#wpa ap(config-ssid)#wpa-psk ascii ap(config-ssid)#exit ¡ Creacion del SSID y método de Autenticación. ap(config)#int d0 ap(config-if)#encryption vlan mode ciphers aes-ccm tkip ap(config-if)#mbssid ap(config-if)#ssid ap(config-if)#exit ¡ ap(config)#int d1 ap(config-if)#enc ap(config-if)#encryption vlan mode ciphers aes-ccm tkip ap(config-if)#mbssid ap(config-if)#ssid ap(config-if)#exit ¡ Método de encriptación. ap(config)#int d0. ap(config-subif)#encapsulation dot1Q ap(config-subif)#bridge-group ap(config-subif)#no shut ap(config-subif)#exit ¡ ap(config)#int d1. ap(config-subif)#encapsulation dot1Q ap(config-subif)#bridge-group ap(config-subif)#no shut ap(config-subif)#exit ¡ ap(config)#int gigabitEthernet 0. ap(config-subif)#encapsulation dot1Q ap(config-subif)#bridge-group ap(config-subif)#exit ¡ ap(config)#int d0. ap(config-subif)#encapsulation dot1Q native ap(config-subif)#bridge-group 1 ap(config-subif)#exit ¡ ap(config)#int d1. ap(config-subif)#encapsulation dot1Q native ap(config-subif)#bridge-group 1 ap(config-subif)#exit ap(config)#int gigabitEthernet 0. ap(config-subif)#encapsulation dot1Q native ap(config-subif)#bridge-group 1 ap(config-subif)#exit **please rate useful answer**

Sorry I attached the example.

Sorry I attached the example.

New Member

Can you have a look if I can

Thank you!

Can you have a look if I can use it like this?

Hall of Fame Super Silver

Since your defining WPA

Since your defining WPA version 2, I would not configure TKIP as the encryption also. Just leave the encryption to AES-CCM.

Scott

-Scott
*** Please rate helpful posts ***
New Member

:) I changed it.

:) I changed it.

141
Views
0
Helpful
5
Replies
CreatePlease login to create content