Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
subject says it all, I failed to find the command in configuration..
Go to Solution.
If this AP is managed by a WLC then you can disable IPv6 on WLC using below command
(WLC) >config ipv6 disable
**** Pls rate all useful responses ****
As per my knowledge, you cant disable from ur AP.
Ipv6 is currently not support on any of the Cisco AP's in autonomous mode. However, they will be able to pass ipv6 traffic.
May be newer IOS version like : Cisco IOS Release 15.2(4)JA supports IPv6 protocols
But I am using standalone firmware for my two 1142's (at home) , not managed AP, - how-to, then ?
thanks, it seemd like that to me too.