Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I configure a 2702 to be a remote survivable AP

I have a 2504 controller and three 2702 APs.  What I am looking for is documentation on how to ensure that if I have a controller failure (since I have only one), that the APs will continue to serve the WLANs independently of the controller.  We are using WPA2 keys which should be fine, but we also have one guest network that utilizes the controller's Webauth page (passthrough mode to merely accept T's and C's) to authenticate clients.  We would like that to also failover to the APs in the event of a controller failure.  Any direction would be most appreciated.

2 REPLIES
VIP Purple

You have to simply configure

You have to simply configure AP in Flexconnect mode & your WPA2 SSID to be configured with FlexConnect local switching. So in this case even WLC is down your branch client will operate normally.

Refer this for FlexConnenct design guides

http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/emob73dg/emob73/ch7_HREA.html

Central web authentication to work WLC shoud be available & that service will be down as long as WLC is down.

 

HTH

Rasika

**** Pls rate all useful responses ****

Bronze

Hi,please go through the

Hi,

please go through the below document link.

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-2/configuration/guide/cg/cg_flexconnect.html

155
Views
0
Helpful
2
Replies