Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how i can see memory amount of AP lightweight

Hello,

in the network, i have a WLC 2112 and two access point lightweight, i need know how much flash an nvram have the access points?

you know what command i set in the WLC for know how much flash an ram have the access point and the Wireless Lan Controller??

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: how i can see memory amount of AP lightweight

You have two options:  You can run debug command and/or enable Telnet/SSH.

To enable debug command on the WLC, run the following commands:

1.  debug ap enable ;
2.  debug ap command "dir" ; (you can also use "sh flash:")

When you are finish or satisfied with the result, disable the debug command.

3.  debug ap disable

To enable Telnet/SSH

Depending on the version of your WLC you do this via GUI or CLI.  The CLI command on the WLC is:  config ap [telnet/ssh] enable

Please don't forget to rate useful posts.

2 REPLIES
Hall of Fame Super Gold

Re: how i can see memory amount of AP lightweight

You have two options:  You can run debug command and/or enable Telnet/SSH.

To enable debug command on the WLC, run the following commands:

1.  debug ap enable ;
2.  debug ap command "dir" ; (you can also use "sh flash:")

When you are finish or satisfied with the result, disable the debug command.

3.  debug ap disable

To enable Telnet/SSH

Depending on the version of your WLC you do this via GUI or CLI.  The CLI command on the WLC is:  config ap [telnet/ssh] enable

Please don't forget to rate useful posts.

Hall of Fame Super Gold

Re: how i can see memory amount of AP lightweight

Thanks for the rating.

330
Views
0
Helpful
2
Replies