Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to Access Wireless Router by GUI

After following configration i am trying to access the router by GUI. But i am not able to. kindly advice.

Interface Name Port Vlan Id IP Address Type Ap Mgr Gu

est

-------------------------------- ---- -------- --------------- ------- ------ --

---

ap-manager 1 30 172.30.30.250 Static Yes No

management 1 30 172.30.30.20 Static No No

virtual N/A N/A 172.25.25.1 Static No N

Thanks in Advance,

Milind Tare

1 REPLY

Re: How to Access Wireless Router by GUI

not enough information. What type of device are you trying to access? NM module in ISR, 210x? what does the config of the connected port look like?

If this is truly a "wireless router" i.e. NM Module in an ISR, issue the following commands:

config wlan disable 1

config interface vlan ap-mananger 0

config interface vlan management 0

Then try to access the device again

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
428
Views
0
Helpful
1
Replies