The tricky question is if the 1600's work behind a MAP. This is what you will have to test. The MESH AP's use a different ssid to communicate on the backhaul, so no matter what WLAN's you configure on the WLC, the mesh has its own. Vlan's are decided when you configure Ethernet bridging as the RAP now needs to be connected to a trunk port along with the MAPs if your going to use multiple vlan's. Or else all traffic will be passed to the native vlan or the vlan that the RAP is on.
Since this is your first time setting this up, all I can say is don't rush it. Set this up in a lab and make sure you have either a power injector or AC power cable to power the mesh Ap or else the radios will not power up if using a PoE switch. Get the RAP up and then one MAP. Understand what's needed before going on. Don't worry about Ethernet bridging until you get the mesh up. If you try to do everything at once, it will be a nightmare and you will never get it working. One thing at a time.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...