Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to configure the Access point 1602 that I just purchased

Hi Everyone,

Hope you can help. I just purchased a AIR-SAP1602I-A-K9 from one internet vendor. Along with it I also purchased an power injector. I tried to use it as a standalone AP. It does not come with any instruction and I am not good at Wifi config. Hope you can help... My setting requirement is very simple:

 

- Create and broadcast SSID called MYCSL

-  Does not need any authentication or encrytion... (is this open authentication?...so that people just connect to the SSID that the user can start to cruise internet without putting in any keys.)

- The access point does not need any static ip assigned, instead, it gets an ip from one of my dhcp server in the network.

- How do I connect my laptop to configure it via web http?

May you tell me what need to be configured? Although this is a new product from a legitimate retailer... Cisco said they could not support it without any Starnet contract... as a consumer...they should give kind of grace period to support the new products...ANyway, hope you can help me here :)


Thank you very much for your help in advance.


Takami Chiro

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

 Hi Takami,Have a look at one

 

Hi Takami,

Have a look at one of the previous posting. I procedure would be more of similar. Hope this will help you to keep started. If you are stuff anywhere please come back to the forum and someone will be able to assist you.

https://supportforums.cisco.com/discussion/12217126/access-point-air-sap1602e-k9

Hope that helps.

Regards

Najaf

3 REPLIES
Gold

 Hi Takami,Have a look at one

 

Hi Takami,

Have a look at one of the previous posting. I procedure would be more of similar. Hope this will help you to keep started. If you are stuff anywhere please come back to the forum and someone will be able to assist you.

https://supportforums.cisco.com/discussion/12217126/access-point-air-sap1602e-k9

Hope that helps.

Regards

Najaf

New Member

Hi Najaf,Thank you very much

Hi Najaf,


Thank you very much for the useful link within the link :) That was very useful and now my AP can function the way i want except one more thing... Now the SSID is broadcast but hidden...and I want it broadcast with "My_SSID" name... may I ask which command I need to issue? I did the "Guest-mode" already. Hope you can tell just one more :)

Thank you!

Takami Chiro

Gold

https://supportforums.cisco

https://supportforums.cisco.com/discussion/12217126/access-point-air-sap1602e-k9

Hi Takamai,

Thanks for marking the answer are correct.

Sorry to say I didn't understand your question. But reading through line I assume your trying to broadcast the SSID..If that is the case you could use "guest-mode" command under the SSID but if you have multiple SSID to be broadcasted then you will have to use "mbssid guest-mode"

Hope that helps

Regards

Najaf

 

232
Views
0
Helpful
3
Replies
CreatePlease to create content