Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
What are the options to configure the WPA on embedded AP in Cisco 1941. I mean to say how to configure WPA encryption on multiple ssid. Lets say i have 2 SSID's . One is encrypted with wep and other need to be encrypted with wpa. Thanks
Q>> What are the options to configure the WPA on embedded AP in Cisco 1941.
ANS>> WPA version 1 and WPA version 2
I mean to say how to configure WPA encryption on multiple ssid. Lets say i have 2 SSID's . One is encrypted with wep and other need to be encrypted with wpa.
ANS >> WPA is the Authentication... not the encryption... WEP is the encryption not authentication..
If we are using WPA.. then no need to configure WEP encryption... the encryption should be either
1>> CHIPHERS TKIP
2>> CIPHERS AES
so the configuration will be..
auth key-management WPA (version 1 or 2)
[you can configure the WPA version by using the question mark after WPA and select the appropriate, version 1 then use TKIP and if VERSION 2 then use AES]
encryption valn X mode ciphers TKIP (WPA) or encryption valn X mode ciphers AES (WPA-v2)
the above wil do it for one SSID.. same way the same config hold good for another if we map the corresponding VLAN..
i request you to let me know how this works out for you!!
I managed to resolve the subject problem. Solution is as below:
AP(config)#interface dot11radio 0
AP(config-if)#encryption vlan xxx mode ciphers tkip
On each SSID
AP(config-ssid)#wpa-psk ascii password