I am looking for a product that will allow me to control the wireless coveragem I would like to allow wireless internet connection in one room, and block access on the other rooms which are 10 meters away, basically I want my clients to be able to surf the internet within the designated area and not in other areas. Is there anyway to control that? or perhaps block the connection in other areas? ideally, I would also like to have a report showing which websites were accessed etc.
The only real way to control this is through the use of power, antenna gain, and attenuators. Use an AP 1242 at very low power with adjustable attenuators to reduce the power or increase the power as needed. Make sure to turn off the 1 and 2 meg beacons so as to not broadcast those in the further rooms that you don't want coverage.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...