Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

how to enable a and g radio on 2602 AP

Hi all

 

I have recently installed a 2602 Standalone AP, However I can only see the N radio config on it, I cant see anyting about a,b or g ?

 

how do I switch these on ?

 

cheers

 

 

5 REPLIES
VIP Purple

The 2.4-GHz radio and 2.4-GHz

The 2.4-GHz radio and 2.4-GHz N radio is radio 0, and the 5-GHz radio and 5-GHz N radios radio 1.

Use these commands to enable:

config t

interface dot11radio 0

no shut

!

interface dot11radio 1

no shut

 

Regards

Community Member

You must use a SSID on the

You must use a SSID on the radio interface otherwise the radio will not activate.

try this.

Conf t

dot11 SSID [name]

auth open

guestmode

!

inter dot11 0

SSID [name]

no shut

!

Inter dot11 1

SSID [name]

no shut

 

Disabling and Enabling the

Disabling and Enabling the Radio Interface

The access point radios are enabled by default. Beginning in privileged EXEC mode, follow these steps to disable the access point radio:

 

 
 
Command
Purpose

Step 1 

configure terminal

Enter global configuration mode.

Step 2 

interface dot11radio { 0 | 1 }

Enter interface configuration mode for the radio interface. The 2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.

Step 3 

shutdown

Disable the radio port.

Step 4 

end

Return to privileged EXEC mode.

Step 5 

copy running-config startup-config

(Optional) Save your entries in the configuration file.

 

Use the no form of the shutdown command to enable the radio port.

Bronze

Hi,Yes, to enable the Radio

Hi,

Yes, to enable the Radio of 2.4GHz and 5GHz, command is same provided by sundeep.

Further in wireless settings page in Wireless LAN section you have drop down of operating mode>

here you can select the b/g, b/g/n mode a/n mode or all those.

 

 

Disabling and Enabling the

Disabling and Enabling the Radio Interface

The access point radios are enabled by default. Beginning in privileged EXEC mode, follow these steps to disable the access point radio:

 

 
 
Command
Purpose

Step 1 

configure terminal

Enter global configuration mode.

Step 2 

interface dot11radio { 0 | 1 }

Enter interface configuration mode for the radio interface. The 2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.

Step 3 

shutdown

Disable the radio port.

Step 4 

end

Return to privileged EXEC mode.

Step 5 

copy running-config startup-config

(Optional) Save your entries in the configuration file.

 

Use the no form of the shutdown command to enable the radio port.

3004
Views
5
Helpful
5
Replies
CreatePlease to create content