Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to enable read-write access on 1242ag GUI

Hi I'm in the middle on setting up some equipment for a customer and am unable to change any settings in the GUI, I have reset the radio and set a default 10.0.0.1 IP in the CLI,  but acn not seem to get anything to change in the default GUI which is nessary  to the customer to manage.

Any Input would be much apprciated.

Everyone's tags (1)
1 REPLY

Re: How to enable read-write access on 1242ag GUI

Hi Peter,

In the moment I'm not able to check this but try to configure the user with privilege level 15 or to set an enable secret.

best regards,
Sebastian

643
Views
0
Helpful
1
Replies