How to enter to Global configuration mode?

[hannu.lehmussaari]

Hi,
I have new Cisco AIR-CAP2602i-E-K9 and I try to configure it via CLI.

I log in, give username and password (defaults) and I'm in User EXEC mode.

Then I type enable and give password to get Privileged EXEC. At least command prompt changed to # and more commads are available.

Then I try to give 'configure' command to get next, Global configuration mode.

Problem: there is no 'configure' named command.

What to do? How to get further?

Best regards,
Hannu

[n4niteshkumar]

Put ? symbol in # prompt and it will show u possible commands,here u can look for configuration related command.

[hannu.lehmussaari]

Problem is, that when I go to Privileged EXEC mode, there is NOT 'configure' command.

[mohanak]

Convert the AP to Autonomous and TRY:

https://supportforums.cisco.com/discussion/11833271/global-configuration-mode-aironet-2600i

[hannu.lehmussaari]

Sounds and looks difficult. Is this the ONLY way?

[Daniel Ordóñez Flores · Accepted solution]

Hi.

If you need to configure something on this AP in CAPWAP mode by CLI, you should write:

"debug capwap console cli" In other case as Mohanak told you you need to convert your AP to Autnomous mode.

**Please rate useful answers**

[hannu.lehmussaari]

That works!

Thanks!

Hannu

[Daniel Ordóñez Flores · Accepted solution]

My pleasure :)