Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to enter to Global configuration mode?

Hi,
I have new Cisco AIR-CAP2602i-E-K9 and I try to configure it via CLI.

I log in, give username and password (defaults) and I'm in User EXEC mode.

Then I type enable and give password to get Privileged EXEC. At least command prompt changed to # and more commads are available.

Then I try to give 'configure' command to get next, Global configuration mode.

Problem: there is no 'configure' named command.

What to do? How to get further?

 

Best regards,
Hannu

2 ACCEPTED SOLUTIONS

Accepted Solutions

Hi.If you need to configure

Hi.

If you need to configure something on this AP in CAPWAP mode by CLI, you should write:

"debug capwap console cli" In other case as Mohanak told you you need to convert your AP to Autnomous mode.

**Please rate useful answers**

My pleasure :)

My pleasure :)

7 REPLIES
Community Member

Put ? symbol in # prompt and

Put ? symbol in # prompt and it will show u possible commands,here u can look for configuration related command.

Community Member

Problem is, that when I go to

Problem is, that when I go to Privileged EXEC mode, there is NOT 'configure' command.

Cisco Employee

Convert the AP to Autonomous

Community Member

Sounds and looks difficult.

Sounds and looks difficult. Is this the ONLY way?

Hi.If you need to configure

Hi.

If you need to configure something on this AP in CAPWAP mode by CLI, you should write:

"debug capwap console cli" In other case as Mohanak told you you need to convert your AP to Autnomous mode.

**Please rate useful answers**

Community Member

That works!Thanks! Hannu

That works!

Thanks!

 

Hannu

My pleasure :)

My pleasure :)

192
Views
0
Helpful
7
Replies
CreatePlease to create content