How to get 300 mbps on Cisco LAP1142N without WLAN Controller
Anyone using Cisco LAP1142N without Wireless LAN Controller and getting 300mbps throughput? I am only using 5 GHz (Manually Disabled 2.4) but i am getting only 144 mbps max throughtput. It would be great if someone can help me to achive around 300 mbps from this AP.
Re: How to get 300 mbps on Cisco LAP1142N without WLAN Controlle
Thanks for your reply. Yes, using Authentication-> open. Under the Radio interface using Channel Width 40-above. Checked with a laptop and it connects with 144 mbps and not getting more then that.
Here is a part of the config:
version 12.4 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname ap ! enable secret 5 $1$0M/H$HIkGshtMt9w5q.KqNvMQf/asdf ! no aaa new-model no ip domain lookup ! ! dot11 syslog !
dot11 ssid TestN2 authentication open
bridge irb ! ! interface Dot11Radio0 no ip address no ip route-cache shutdown antenna gain 0 station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled ! interface Dot11Radio1 no ip address no ip route-cache ! ssid TestN2 ! antenna gain 0 no dfs band block speed basic-6.0 basic-9.0 basic-12.0 basic-18.0 basic-24.0 basic-36.0 basic-48.0 basic-54.0 m0. m1. m2. m3. m4. m5. m6. m7. m8. m9. m10. m11. m12. m13. m14. m15. channel width 40-above channel dfs station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled !
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...