Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to go in GUI mode of AIR-LAP 1131AG-A-K9 standlone

hi

i am using above model of access point without controller.For that we tried to convert LAP to autonomous mode but didnt get success.Here am attaching log viewer of tftp server.

2 REPLIES
Bronze

Re: How to go in GUI mode of AIR-LAP 1131AG-A-K9 standlone

The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.

Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, and c1240-k9w7-tar.default for a 1240 series access point.

New Member

Re: How to go in GUI mode of AIR-LAP 1131AG-A-K9 standlone

Hello,

As I'm seeing is that it takes about 15 seconds to fire the timeout! are you sure that the file is not copied to the AP ? I didn't tried that before, but I can suggest some ideas:

-can verify of the file is not corrupted

-or try to use another TFTP server! which one you are using?

Regards.

187
Views
0
Helpful
2
Replies
CreatePlease login to create content