how to login and manage 1200 G-series Access Point
I have several 1200 G-series Access Points that were already setup and configured before I arrived here and now I want to be able to manage them and at least be able to login and view the config on these.
Re: how to login and manage 1200 G-series Access Point
Either with a web browser (just point it at the APs IP address), by telnetting to the APs or by plugging in a console cable and using Hyperterminal. In any case you'll need the credentials to log in, the default username/password is Cisco/Cisco . If they've been changed and you have no record then you'll need to perform password recovery on them.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...