In my WLAN enviornment there are multiple heavy, block walls. In some locations the AP may be stored securely in a closet while the antennas are routed through the ceiling and down into a room with concrete block walls. What I'm wondering is, how can I place the AP's antennas in a different location than the AP on a map in WCS?
Also in some locations I'm using a Yagi directional antenna, how can WCS take this into account?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...