Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to prevent a choice of a specific channel in case of autodetection channel (is solved!)

There is AIR-AP1142N-R-K9 with configured auto detection of frequency:

interface Dot11Radio0

  channel least-congested

!

interface Dot11Radio1

  channel least-congested

!

How to prevent a choice of a specific channel in case of 'channel least-congested' on 'interface Dot11Radio0' (for example, prevent from autodetection 'channel 13') ?

Everyone's tags (2)
6 REPLIES

How to prevent a choice of a specific channel in case of autodet

Hello Anton,

If dynamic selection of frequency is opted, and you want a particular group of frequency be not selected,

follow the below step

Remember different frequency groups are represented by the 15 diff. channels

dfs band frequency-group block

Example:

AP(config-if)# dfs band 1 2 block

Prevents an access point from selecting a specific group of frequencies during DFS.

The frequency-group value can be 1, 2, 3, or 4:

1 specifies frequencies 5.150 to 5.250 GHz.

2 specifies frequencies 5.250 to 5.350 GHz.

3 specifies frequencies 5.470 to 5.725 GHz.

4 specifies frequencies 5.725 to 5.825 GHz.

At least one group of frequencies must be specified. Multiple groups are allowed.

New Member

How to prevent a choice of a specific channel in case of autodet

Hi, Saurav Lodh

Cisco 1142 with current IOS doesn't support this commands. Even if this command would be supported, all the same it restricts only the certain unit of frequencies on the 5GHz-interface (interface Dot11Radio1).

How to prevent a choice of a specific channel in case of autodet

I'm not sure you can do what you want in IOS.... Can you buy a WLC?

New Member

Re: How to prevent a choice of a specific channel in case of aut

Hi, Richard


How WLC will cope with it? It executes the same operations & automatically sets up frequencies on all points, but it doesn't decide an objective.

Cisco Employee

How to prevent a choice of a specific channel in case of autodet

Two choices at the same time not possible.

Either you may select autodetect or the desired channel.

New Member

Re: How to prevent a choice of a specific channel in case of aut

Hi, Abha

It not absolutely so... I found a solution, as it turned out, all the "brilliant and simple," I wonder why I just did not see it

interface Dot11Radio0

channel least-congested 2412 2417 2422 2427 2432 2437 2442 2447 2452 2457 2462 2467

!

...thus the channel is selected, only the frequency of the proposed (in example: 1 through 12, exclude 13)!

379
Views
0
Helpful
6
Replies