I cannot find where to reboot an individual AP? I have clients that are connect to an AP upstairs and the signal is weak. I have an AP located in the same room as AP but clients do not connect. Where can i reboot the AP that I do not want clients to connnect to. thanks
From the GUI, click on the wireless tab and then click on the ap you wish to reboot. On the bottom of the ap general page, you will see a reboot ap button. You would click on that to reboot the AP. You probably need to look at why the ap's can't connect to that ap.
Yeah that is why I want to reboot the indivdual AP. I am trying to determine why clients are not connecting to the closest device.. Anyhow, I don't have the option to reboot. I see "reset AP now"- that completes a hardware reset. Right?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...