Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how to sync AP names from WLC to WCS

when AP names are updated on a WLC, how to propagate the changes to the WCS? WCS still shows the AP names as MAC addresses instead of user-friendly names that were set on the WLC.

1 REPLY
Community Member

Re: how to sync AP names from WLC to WCS

In 4.2.61 you go under the controller tab on the WCS and select the controllers that you would like to update. Select the drop down for 'Refresh config from controller' Select then select the delete tab on the following screen. This will take all the information from the WLC and move it to the WCS and delete any outdated information on the WCS. Hope this helps.

182
Views
0
Helpful
1
Replies
CreatePlease to create content