What scripting method / language are you wanting to use?
You would use the same commands you'd use if you were connected via the console or telnet, maybe a tftp transfer, or you could just pump the raw command text for the command.
Also, how "automatic" does it have to be? Are you going to have the script fired by a timer (connect, do changes, disconnect), or will the connection be done manually, and you just want to automate the change process once the connection is made?
Let's not get into a "20 questions" thing: what do you want to do, and how do you want to do it?
Scripting language isn't the problem. For exemple, perl. My problem are cisco commands.
I have to change the configuration of a lot of 1100 & 1200, and I need to do it in a less time that could be possible. So I was thinking in prepare all the config files for each AP. Anf after write a script like;
connect 1st AP; upload config.file1
connect 2nd AP; upload config.file2
connect 3rd AP; upload config.file3
(of course it could be made by a 'for' sentence)
But I don't know if there's a command to upload all the config file. It exists?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...