I have a 5508 in my primary data center, but want to add one in my BDC
I have two 5508’s one is running and supporting all of my 100+ CAPWAP AP’s.But I need to bring up a redundant WLC in my back-up-data center.The two data centers are connected via 10 Gig pipe with a 100 Meg MPLS as backup.
I have one with CT5508-100-K9 and the other with CT508-HA-K9.How do I do the HA since I can’t connect the two WLC together with an Ethernet cable.
I have been looking for a deployment guide that has this config but have not found one.
Re: I have a 5508 in my primary data center, but want to add one
Because you have an HA SKU you would have to extend the layer 2 vlan to the data center. WLC version 7.5 supports connecting the RP port to a switch previous to 7.5 cisco stated that they should be directly connected. Read the above guide that Leo posted and it will give you more details on "how to" if you can't extend the layer 2 then you will need an non HA-SKU controller.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...