I have a AIR-WLC2112-K9 is not opening in GUI

[takyon.networks]

when i reset the device it is open in by default ip in GUI but when i configure the device after that when i enter save and reboot command it is not open with new ip in gui.

[Justin Kurynny]

Raj,

On which WLC interface are you assigning it a new IP? Make sure you are changing the management interface (and not ap-manager).

Try closing and reopening your browser or using a different browser than the one you used to make the change, or even trying from another computer altogether.

Try http://. There have been a rare number of times that I've seen the secure web (https) somehow get disabled on the WLC and only http works until I re-enable https.

Managing the WLC while connected to it as a wireless client will fail unless you disable management-over-wireless blocking on the WLC. Make sure you are doing your WLC setup over a wired connection.

Justin

Sent from Cisco Technical Support iPhone App

[takyon.networks]

Dear,

I have configured like this by command prompt....

Management Interface IP - 192.168.1.2,Subnet - 255.255.255.0, Gateway -

192.168.1.1, Port - 1,Vlan - 0 (untagged)

AP Manager IP Address - 192.168.1.3, Subnet - 255.255.255.0, Gateway -

192.168.1.1, Port - 2,Vlan - 0 (untagged)

When i reset the controller,after reboot first time it is open with this ip

192.168.1.1 but when i configure the device with uuper given detail and

enter save and reboot option after reboot it is not open by 192.168.1.2

ip.i connect my laptop to port 1 of controller to access controller.

Thanks

RAJKUMAR

+91-8874555503

On Fri, Feb 24, 2012 at 1:35 PM, airframes <

[Scott Fella]

Raj,

If you are trying to access the WLC, either configure the Service Port and connect directly to that so you can access the GUI or connect port 1 of the WLC to a trunk port and then connect your laptop or pc to a switchport on the same vlan as the wlc management interface. You shouldn't connect your device directly to the wlc. Hopefully I'm understanding your issue here.

Sent from Cisco Technical Support iPhone App