I have cisco air-lap1142-E-k9 without any OS(only boot loader Version 12.4(23c)JA3, RELEASE SOFTWARE (fc1)). I need upgrade it to lightweight.
What I already did:
1. I tried to start device with pressed MODE button(how described in https://supportforums.cisco.com/document/57476/lwapp-autonomous-conversion-and-vice-versa-access-points), but I didn't have ping between host and cisco. 2. I tried get ip to my cisco device, but cisco don't know those commands. List of the enable commands ap: ? ? -- Present list of available commands arp -- Show arp table or arp-resolve an address boot -- Load and boot an executable image cat -- Concatenate (type) file(s) clear_ether -- clear ethernet port statistics copy -- Copy a file delete -- Delete file(s) dir -- List files in directories dump_regs -- dump reset registers etest -- test emac driver code ether_init -- initialize ethernet port flash_init -- Initialize flash filesystem(s) format -- Format a filesystem fsck -- Check filesystem consistency help -- Present list of available commands init_pci -- initialize pci bridge led_test -- cycle LED patterns load_helper -- Load and initialize a helper image memory -- Present memory heap utilization information mkdir -- Create dir(s) more -- Concatenate (display) file(s) phy_dump -- dump phy registers phy_read -- read phy register phy_write -- write phy register rename -- Rename a file reset -- Reset the system rmdir -- Delete empty dir(s) set -- Set or display environment variables set_baud -- set baud rates set_sleep -- Pause (sleep) for a specified number of seconds show_ether -- show ethernet port statistics show_pci -- show pci setting switch status -- report push button switch status tar -- extract or listing a tar file tftp_init -- Initialize tftp file system type -- Concatenate (type) file(s) unset -- Unset one or more environment variables version -- Display boot loader version warm_pci -- warm pci rst
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...