Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I've got a hosed 1131ag...I think

So I've got a 4402, which I've configured and everything there should be good to go.

I associated a new 1131AG this morning. I used DHCP to give out IP addresses, and manually input the WLC IP Address into the AP via the LWAPP command.

The AP has since disacciated from the WLC. There are no APs registered in the WLC. In the AP, I can't get into any of the LWAPP commands, nor can I execute clear ap private-config. Hitting Escape during boot process while it's loading the IOS image is fruitless, as is Ctrl-Break.

Any help would be much appreciated.

- Mike

1 REPLY
New Member

Re: I've got a hosed 1131ag...I think

Actually...

I figured out how to do the MODE reset. That ended up working.

128
Views
0
Helpful
1
Replies
CreatePlease login to create content