I have two 5508 WLC IOS code 18.104.22.168 in the both wlc I am having the same code. But in the one wlc i am having Russia image as below mention...
Cisco Unified Wireless Network Software Release 7.6 for Cisco 5500 Series Wireless LAN Controllers with Licensed Payload Encryption.Only Recommended for Russia Where Data DTLS Payload Encryption is Regulated by the Government. AIR-CT5500-LDPE-K9-7-6-120-0.aes & in the 2nd wlc Cisco Unified Wireless Network Software Release 7.6 for Cisco 5500 Series Wireless LAN Controllers. AIR-CT5500-K9-7-6-120-0.aes. In this case can I configure HA one like as primary & 2nd wlc as standby mode use the same license in the both wlc. I bye it two separately box before 2 years.
IOS code will be the same but image is change. It's possible for HA. When I buy it that time both wlc ios code is 7.0.X.X & 7.5.X.X.
If possible then how can do for the same. or it's not possible. I am try to convert as normal ios code but it's not accepted. Only upgrade with Russia ios code.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...