Installation Aironet 2602i and Controller 5508, powering of the access points
Hello, I have a wireless network to deploy on two floors with the following equipment:
A wireless Controller Cisco 5508 and 4 Aironet 2602i Access Points. Two access points will be installed on each floor. All networks outlets on the two floors converge to a technical room on the first floor. I would like to connect the access points to the network outlets so that they will be connected to the controller 5508 in the technical room. Now there is the problem of powering the access points (which support POE), how do I proceed?
Installation Aironet 2602i and Controller 5508, powering of the
You can plug the Access Points into a switch (preferably a 3560 or 3750) that support POE. Once the AP is connected to a POE switch then the AP will obtain power from the switch via Ethernet. Hence the acronym POE (Power-Over Ethernet). Hope this helps!
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...