I hope this is in the right area, so here it goes.
I am trying to layout an access point install consisting of Aironet 1310's. It is for a warehouse location and it is at 0 degrees all the time so it was a good choice considering there broad temperature range. However I am not sure how exactly to lay them out to get good coverage. I have thought about mouting at the end of an aisle and then running a cable (for the second antenna) to the other end of the aisle. The other thought would be to mount one every other aisle and run a cable over to the next aisle and get coverage that way. I guess my questions are, which will provide me the best coverage without having to run large amounts of cable?
To answer your question you will have to provide much more information on the area where you plan to deploy the Wireless network. I would suggest that you perform a site survey for best results. There are lot of firms which specialise in site survey. A good site survey will help you determine the correct placement locations for your wireless devices and also ensure complete coverage.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...