I ran into a bit of a brick wall with my WebAuth deployment and was hoping I could get a fairly quick answer.
I'm running version 188.8.131.52 on my WiSM blade.
The problem is that the text on the 'Message' field doesn't wrap. That is: if it reaches a certain length it just keeps going so that the webauth page scrolls to the right, on a single line. My security guy wants to put a wireless usage disclaimer here but it's looking like this won't be possible due to the fact his small paragraph won't wrap.
Is there any way to get around this issue? Perhaps a CLI command that I'm missing?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...