I have started converting our Access Points to the IOS software. So far, I have two 1200 access points that will stop authenticating clients after about 4 days. I was wondering what others are experiencing with the conversion to the IOS software and what you are doing to resolve problems.
I have not experienced that but some other strange stuff after converting. What I do now is convert the ap and reset it to defaults. Then I tftp up the config.Its the old saying something gets lost in the translation.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...